The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: slave cylinder on clutch (archive)

[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]

Posted by Clement Schmitt on March 08, 2000 at 01:42:23:

In Reply to: slave cylinder on clutch posted by Art on March 07, 2000 at 20:34:46:

: Have been trying to get the cylinder loose. Have the clip off the engine side. Can't get to the clip on the clutch side with snap-ring pliers. Should I be able to turn the cylinder or slide it toward the clutch? I'm trying to bleed the line and was told to get the bleed on the top side. Can't get enought travel out of the fork to release the clutch. Any suggestions appreciated. Thanks.

You should be able to slip it out toward the rear of the car. Try penetrating oil and/or big pump pliers to turn it back and forth while moving it outward.

I don't believe the bleed valve cares which way it points. Just place a tube on it and put the other end in a container with brake fluid just as you do when bleeding brakes.

When bleeding fails to yeild the desired results, replace the slave cylinder.

Good luck.




Follow Ups:



[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2016 Jump Internet Inc. All rights reserved.