The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: timing chain alignment........... (archive)

[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]

Posted by jefrem on March 13, 2000 at 11:12:34:

In Reply to: timing chain alignment........... posted by alex (uk) on March 11, 2000 at 06:12:35:

: just pulled my head due to blowing gasket, had it skimmed and have bolted it back on. but the valves seem louder then before, have set them to .008 but still sounds like one is wrong. could i have the timing chain out by one tooth? the crankshaft is at top dead centre when the timing mark lines up with the pointer, and on the head the dowel on the chain wheel is at the lowest point, but if i move the crank a little the top stays still, i think i have all the slack on the tensioner side but not 100% sure, any help appreciated!




Follow Ups:



[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.