The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: advice! (archive)
[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Posted by Delk on March 27, 2000 at 11:18:38:

In Reply to: help! need guibo installation advice! posted by tim on March 26, 2000 at 11:00:10:

: putting in a new guibo (old one badly cracked. working on getting the prop shaft out. couple of questions. do i need to remove the whole driveshaft (or another way of saying it would be - is the job easier if i remove the whole thing) or can i do it with only removing the prop shaft? i plan on putting in new center support bearings so i have to seperate the driveshaft. after i get it out and am reinstalling the new guibo - haynes says the torque on the bolts holding the guibo should be 48 lbs. how can you adjust the torque on the nuts holding the guibo to the tranny flange? I can't figure a way to get a torque wrench in that little area. is it just "best guess"? thank god for the 17mm bent wrench that came with the original toolkit or i never would have gotten the old bolts out. can anyone offer some advice? TIA, tim

lossen the ceter support bearing , gusess at the torque,good luck

Follow Ups:


[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.