The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: removing stabilizer bar (archive)
[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Posted by Rob C. on April 02, 2000 at 16:01:05:

In Reply to: removing stabilizer bar posted by Harvey Rogan on April 02, 2000 at 15:23:40:

: Can get boxed end wrench on nut at top but can't get socket or wrench on bolt head.

Harvey -- Your 72 tii may be different from my 74 2002, but for what it's worth, I encountered a similar problem. My stablizer bar bushing assembly was set up so the nut was on top, and the bolt head (which is a hex-type bolt) was on the bottom. I managed to get a box wrench on the nut. Then I took a hex bit and turned the bolt head from the bottom, instead of turning the nut (I usually try to avoid doing it this way, but I had no choice). Worked like a charm.

Again, your tii may have a different setup.

Incidentally, when reassembling the bushing bracket, I found that a solid flat-head screwdriver provided some much-needed "persuasion" to get everything lined up right.

Hope this helps.

--Rob C. ('74 2002/A, Sahara)

Follow Ups:


[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2008 Jump Internet Inc. All rights reserved.