The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
'76 resistor wire/pertronix hookup help (archive)
[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Posted by sam smith on April 09, 2000 at 01:31:12:

Ok, how do I place the pertronix red lead (pos) in front of the resistor wire when it runs from the positive coil terminal all the way to the ignition switch? I'm guessing I can just find a switched 12v source, but where would that be?

Or can I just tap into the resistor wire as is? This'd be a hell of a lot easier to figure out if I had a ceramic-type resistor. I've done a bunch of ignition/electrical FAQ reading on the net, but am still slightly fuzzy on this stuff.

Help!

-Sam
'76 inka

Follow Ups:


[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2008 Jump Internet Inc. All rights reserved.