The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
trans wobble!!!! (archive)

[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]

Posted by stone on April 24, 2000 at 21:15:15:

In Reply to: bad NVH on launch -'73 tii posted by Michael Cari on April 24, 2000 at 20:54:10:

HI,
the trans mount that you want is for both
4sp and 5sp trans'. to install put floor
jack under trans on centerline rib. then raise
slowly untill the mount looks loose then
remove top nut (17mm).no the trans should not
hit the tunnel. after this is done then test
drive to see if it still wobbles. if so then
replace the rubber drive gear between the
front of the drive shaft and the output flange.
this is called a guibo and is about the size
of a large glazed danish, it has either 6 or
8 bolts that hold it to the shaft and the trans.
to remove take off only the bolts that will
release it from the trans. then unbolt the
center bearing and swing the shaft out to a
better position to change the guibo.
its not tough just laborous. call if you have trouble. good luck
stone
stone racing co
phila pa
215.592.0265




Follow Ups:



[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.