2002 76 ignition switch (archive)

Hi,
this job is not though. it just takes
some time and patience.
remove panels under driverside dash
now remove the plastic panel under the column
on the bottom.
on the underside of the lock cylinder
housing there is a small retainer pin pushed
through the housing and into the cylinder.
get a 1/8 drill bit and drill out the roll
pin. only drill in about 3mm-5mm. just enough
to get through and not into the cylinder.
put the key into the cylinder and remove the
lock cylinder. dont turn the steering wheel
or aggrevate the column because the stuff in the
lock socket is spring loaded.
the cylinder is repairable at a locksmith
if not i can get you a used one or a new one.
questions call or e-mail me. good luck
stone
stone racing co
phila pa
215.592.0265

Follow Ups:

[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]

Questions, comments, or problems, please visit the Roadfly help desk.