The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Questions about a Head Job ;) (archive)
[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Posted by Dr. 02 Majik on February 11, 2001 at 23:02:34:

No Pun intended :)
I'm going to be refreshin the 121ti head on my 02 rather shortly... running a 40 sidedrafts... puttin in a 292 cam with oversized valves.. gettin it flowed.. I was looking at the head today... once I take off the timing chain cover and disassemble is there a way I can keep the timing chain snug and up there... the chain tensioner says it's oil dampened with a stop on it so it shouldn't shoot out.. was planning to prob just jam a piece of wood or something to keep the timign chain snug around the lower bits... would like to avoid taking apart the lower piece to align the timing chain again.. Ne one have experience with this and offer ne words of wisdom before I embark upon this adventure?? It's always greatly apreciated...

Follow Ups:


[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.