OK here it is. on the front of the 'round thing' you will find a small pin size looking hole near the edge, that does not go all the way though. the hole is right behind this about midway from the edge.

on the rear panel, the arm rests are attached to the panel. take the rear bottom seat out then the back seat part(two screws on the bottom,one each side mid seat i beleve) lift bottom out then up. and then with a panel tool(two prong fork looking thing you can get at a automotive body supply house) pop the panel out by going around the edges. you may have to pull the seat belts off(72 and latter with the retractable types i belive) then after the bottom and edges are lose, pull out and gently up.

the front is the same, but lose the srews holding the arm rests in. make sure your plastic is intackt and lube all your window stuf while you are in there. is your door brake ok? if not give maximilian imports a call