The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
93.5 is a lot.... (archive)
[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Posted by Jonathan T. on July 08, 2001 at 22:54:54:

In Reply to: Block Over Bore posted by Greg Taylor on July 08, 2001 at 16:32:41:

Youd be well off to have a few blocks around before hand. The bores were never intended to go that big and I have been told the castings are less consistant that far out from the original wall. The iron does nott cool the same all the way through. I think even 92 is a lot.

Good luck and enjoy,

Jonathan T.
Can you bore the m10 block to 93.5 to accept the s14 piston?And if you can,would the whole s14 rotating assembly bolt in,or does the m10 have a different deck height? Thanks to those who know!




Follow Ups:


[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2008 Jump Internet Inc. All rights reserved.