The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Wait-top & bottom of subframe bshings aren't same (archive)
[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Posted by MartyR on September 03, 2001 at 18:53:04:

In Reply to: I don't think so... posted by Tkent02 on September 03, 2001 at 13:33:34:


The height of the upper spring perch does not change, nor the lower one on the arm, so the height stays the same. What changes is that the pivots are higher, so the arms will be in a lower position in thier travel so the camber will be as if the car was riding higher. Confused yet?

As installed from the factory, the TALLER end is installed upwards. Sooo---that means that if you flip 'em, the subframe is closer to the chassis. Seems to me like that's toying with disaster...the diff wouldn't be aligned properly and things are generally much closer together than they were designed to be. Spend $300 on rear camber adjustment gear...

Marty
'73(s)


Follow Ups:


[ Follow Ups ] [ 2002 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.