The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: Help with front clear blinker install (xenon). (archive)

[ Follow Ups ] [ 5-series (E39) Message Board ] [ Msg. Board FAQ ]

Posted by peter on August 15, 1999 at 08:46:31:

In Reply to: Help with front clear blinker install (xenon)... posted by Brad D on August 14, 1999 at 19:12:58:

I dont have Zeons, but I beleive the clip system is the same. I R/R the headlights in about 10 mins each. Also both of my headlights had something done to one clip to prevent front being taken apart. The spot weld the platic, thus i used a sharp knife and cut this away before a could proceed.
The staple in the clips should be fairly easy.
Take wire cutter and cut in the middle then use needle nose to pull out, do it slowly and work it out. The pastic clips are not very strong.
good luck.
I think the seal is from hella and a way to test if it was sealed and then passed tests and stapled or spotwelded.
The trip to getting a good seal whe replacing the lens cover, use a new gasket, my kit came with new seal. Do one light at a time, thus you have a reference




Follow Ups:



[ Follow Ups ] [ 5-series (E39) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.