The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Got it. Thank you very much Larry. (archive)
[ Follow Ups ] [ 5-series (E39) Message Board ] [ Msg. Board FAQ ]
Posted by STT on June 26, 2000 at 13:58:06:

In Reply to: Re: Larry...I posted that some weeks ago, more posted by Larry on June 26, 2000 at 13:29:49:

: : Before you install the new diff you MUST remove the axle flanges from the 2.81 and use those to replace the ones that came with the 3.15...it's not difficult, just pull off the retaining clips you see at the end of the diff's inner axles and out u go.
: : Galo

:
: Galo,

: Thanks for the reply. I feel MUCH better now! Were you able to easily re-use the gasket for re-assembly?

: Later this evening, when I have a few more minutes, I will ellaborate on the secret of removal. Essentially, the Diff. must be turned completely upside down in order to be able to slide it off the bolts on the drive shaft CV joint. The task is quite simple when you figure this out (I won't tell how look this took me). However, if you are on Jack stands (like me) you have to do this manuvering while holding up with your stomach or chest instead of a jack.

: Thanks again for everyone's quick replies.

: Larry



Follow Ups:


[ Follow Ups ] [ 5-series (E39) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.