The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
This is how!!! Been there...done that! (archive)
[ Follow Ups ] [ 7-series Message Board ] [ Msg. Board FAQ ]
Posted by Salts on October 02, 2000 at 11:52:46:

In Reply to: Re: Headlight Removal -- Help posted by Eric on October 01, 2000 at 20:55:38:

Your are almost there. The trick is to slide the body molding below the head light to the center so you can remove it. then slide the retainer clips you mentioned (adjacent to the side markers)...now use a flash light to look between the bottom of the headlight assembly and the top of the bumper...you will see two "torque" nuts. Use the proper side torqe screw driver to remove them. Search this page for "headlamp lenses" and you will find an earlier post that I have out their with the proper size of torque screw driver. Good luck.


I am looking at some instructions and I don't see the nut that you are talking about. I have a drawing that I can fax to you, just email me at enelson@cnc.com.
I assume this car does not have HID lights? Did you actually remove the trim below the lights (it really does just slide toward the center of the car). If not, then I can see how you could be hung up.




Follow Ups:


[ Follow Ups ] [ 7-series Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2008 Jump Internet Inc. All rights reserved.