The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: Dinan Parts install??? (archive)
[ Follow Ups ] [ 7-series Message Board ] [ Msg. Board FAQ ]
Posted by Caesar on August 06, 2001 at 00:01:05:

In Reply to: Re: Dinan Parts install??? posted by Simeon on August 04, 2001 at 10:02:23:

I will have Dinan do the computer, I just don't want to pay full tilt labor rate from Dinan if I can get my buddies at the dealership to do it for a six pack.

Appartley the car will run with the componets only throwing a check engine light as would hurt anthing if you don't run full throttle.
Ceasar,
Installing these components is not too dificult. The CAI will require you to cut a 3x5" square intake port into the bottom surface of the front bumper (to allow cold air to the K&N filter). I am curious though,
Who will reprogram the ECU to allow more fuel due to the increased airflow?

Simeon

Anyone tried installing the Cold Air intake, Mass Airflow meter and throttle body themselves??? Was it difficult/easy, any suggestions???





Follow Ups:


[ Follow Ups ] [ 7-series Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.