The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: replace drive belt (archive)
[ Follow Ups ] [ 7-series Message Board ] [ Msg. Board FAQ ]
Posted by James on December 09, 2001 at 22:17:45:

In Reply to: Re: replace drive belt posted by Scott on December 09, 2001 at 19:53:49:

Thanks a lot Scott!

-James


I believe it is a DIY.

1. Remove fan. (this is a left handed nut) I use a large screw driver and a hammer and tap it. This usually will loosen without any problems with one sharp blow. Then just spin the fan off clockwise.

2. Loosen the two or three tensioner bolts just behind the idler pulley. This should take the tension off of the belt. Note the belt configuration around the pulleys

3. Remove the idler pulley completely.

4. Install new belt.

5. Replace idler pulley.

6. Retension belt and tighten tensioner bolts.

Good luck.

I have a 98 740iL. The power steering drive belt broke while I was driving. The car has 57000 miles.

Is it a DIY job to replace the drive belt? Does anybody have a step by step instruction?

Thanks in advance!

-James





Follow Ups:


[ Follow Ups ] [ 7-series Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.