The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: What is involved in installing a sunroof wind. (archive)
[ Follow Ups ] [ 7-series Message Board ] [ Msg. Board FAQ ]
Posted by cherry on March 11, 2002 at 21:00:18:

In Reply to: Re: What is involved in installing a sunroof wind. posted by WTH on March 11, 2002 at 13:38:45:


Cherry - The TIS suggests taping exterior perimeter of sunroof opening to the roof to determine if that is the source of noise.
If so, then it suggests replacement w/ new gasket. It is also specified that the glass be flush-to-1mm lower at front edge; and flush-to-1mm higher at rear edge than surrounding roof.
My experience has been that if I pushed the switch (as when moving into vent position) in small increments, the noise was substantially reduced - indicating, I think, that my sunroof needed adjustment of its "parked" position.

Thanks for the tape recommendation. I will try that first.

Cherry


Follow Ups:


[ Follow Ups ] [ 7-series Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.