The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: Any advice on valve ajustment on 320i (archive)
[ Follow Ups ] [ 3-series (E21) Message Board ] [ Msg. Board FAQ ]
Posted by Frank on October 10, 2000 at 13:17:11:

In Reply to: Re: Any advice on valve ajustment on 320i posted by Ed Walker on September 21, 2000 at 11:23:27:

Planning on replacing valve cover gasket this weekend, thought it would be a good time to quiet things down some. Have always tightened until noise stops then reverse 1/2 turn. Is this safe? thanks t.g.


I don't know about "safe", but it can't be very accurate. Given the cost of a set of feeler gauges, it strikes me as a poor way of doing things.

Ed Walker
'80 323i
'72 tii


you have to adjust each with cam lobe pointed down at the engine. adjust to a tight .007 or loose .006. They have to be adjusted in order. I believe it is 3,1,2,4.
I pull (or loosen) the spark plugs so I can manually turn the engine over. Must be sure to turn the engine over the correct way.

Follow Ups:


[ Follow Ups ] [ 3-series (E21) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.