The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Flat conn. not used unless you have clock only.... (archive)
[ Follow Ups ] [ 7-series (E23) Message Board ] [ Msg. Board FAQ ]
Posted by Bob745 on December 23, 2001 at 01:04:26:

In Reply to: Wiring diagram for Dashboard (A/C controls, etc.) posted by Chip Beardsley on December 23, 2001 at 00:40:42:


The switch was able to move past zero because the black plastic tab broke off. You'll need to glue someting there to keep it from happening again or you'll be going right back into the dash in short order. The easiest way to rig this is to glue a thin piece of plastic to the side of the piece which lights up and is inserted in the top of the wheel. Its the piece that the label "Fan" attaches to.

If that's too confusing email me offline and I'll try to give a better explanation.



Follow Ups:


[ Follow Ups ] [ 7-series (E23) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.