Re: SI lights/Reset (archive)
[ Follow Ups ] [ 6-series (E24) Message Board ] [ Msg. Board FAQ ]
Posted by Dan P on May 27, 2000 at 23:27:53:
In Reply to: SI lights/Reset posted by Robin F. on May 27, 2000 at 10:34:37:
(posted from: p111.amax3.dialup.abq2.flash.net (216.215.109.111))
: Last week my car blew the main relay, which I have since replaced. Since then, my SI lights red through yellow have been flashing. Which pins do I need to jump to reset the lights? they're starting to hipnotise me in stop and go traffic. Also is there a fuse somewhere other than the fuse box for the OBC? My OBC has not worked since I bought the car and I would like to fix it before I sell it. One more question, I tried resetting my radio code and lost the display, the radio never reset. I tried to reset the radio by leaving the radio and ignition on for 1 hour ( actually I was driving in stop and go traffic again)without touching and buttons on the radio. The display never came back nor my reception. Any ideas? I'm starting to go nuts in traffic.
: TIA,
: Robin F.
: 84 633, 150K Not sure about the radio, but can help w/ the re-set. Find the engine maintenance connector and pull off the red plastic cover. Looking at the flat side to your left, it's the center pin and the adjoining lower right (about 4 o'clock position from center pin). If any doubts, go to nearest bookstore and find yellow BMW Enthusiast's Companion book (pages 122-123)for article on building $5 Indicator Reset Tool.
Follow Ups:
[ Follow Ups ] [ 6-series (E24) Message Board ] [ Msg. Board FAQ ]