The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: what tools needed to replace lower control arm (archive)

[ Follow Ups ] [ 5-series (E28) Message Board ] [ Msg. Board FAQ ]

Posted by Glenn on January 13, 2001 at 00:13:07:

In Reply to: Re: what tools needed to replace lower control arm posted by jaydogboy on January 12, 2001 at 22:05:36:

I'm doing this job tomorrow morning and I'm wondering if I need anything besides what's in my tool box. I think I need to get replacement locking nuts for the bushing end pivot, too, correct?

Scottie


No special tools although if you are reusing the arms you would want to use a ball joint press, otherwise a couple of raps with the hammer should pop them. I assume you are replacing the arms because the ball joints are gone? Are you using a stock replacement arm and bushing? I would take this opportunity to upgrade the locator bushings with the 750i units. You can use a bearing press and have the old ones swapped out in a 1/2 hour. I had a local shop do mine, chump change. I used a 1/2" bolt, 2 washers and 2 nuts to "spread" the locator bushing mounts so tht the wider bushings would fit. A torque wrench should be used on the ball joint end, check the Bentley for specs.

Good luck,


Make sure you tight all the bolts with the bushing loaded (with all four tires on the ground) you can do this simply with your jack under the control arm, but be carefull were you place it and don't bend the control arm.


Follow Ups:



[ Follow Ups ] [ 5-series (E28) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.