The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: Help! fan removal (archive)
[ Follow Ups ] [ 5-series (E28) Message Board ] [ Msg. Board FAQ ]
Posted by Chuck on September 09, 2001 at 15:43:02:

In Reply to: Help! fan removal posted by Dan on September 09, 2001 at 12:36:20:


You would be better off removing the plastic fan shroud to replace the belts. This allows much more room to get at them. Otherwise, you'll need a special tool to hold the pulley in place while you remove the fan bolt; usually done only to replace the distributor cap or water pump.
Good luck
Chuck/88 535i/102k


Does anyone have any good ideas for removing the fan?
My '88 535i has the single, large nut (24mm I believe)holding the fan to the water pump. Yesterday, I lost the fan belt & I'm trying to install the new one today.
I can't get the new belt past the fan without damaging the radiator, and I can't get the pulley to stop spinning when I try to loosen the nut (reverse thread, correct?)in order to remove the fan.
If anyone has any tips, I sure could use them right about now.

TIA,
Dan




Follow Ups:


[ Follow Ups ] [ 5-series (E28) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2008 Jump Internet Inc. All rights reserved.