The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Jim, could you post your dyno printouts??? (archive)
[ Follow Ups ] [ M5 (E28) Message Board ] [ Msg. Board FAQ ]
Posted by Sheldon on February 11, 2002 at 10:32:03:

In Reply to: Re: Modern Performance MAF conversion posted by J Taft on February 09, 2002 at 00:21:45:

Would love to see your results compared to mine, especially the air-fuel ratio. Did you see my post from above?


I have no experiance with Modern Performance but have been running Split Second for the last 2 years on my 88 M6. I set the 4 signal conditioner rheostats on the recommended settings and the motor ran as smooth or smoother than the AFM from the first start. Dyno'd the car on a Dynojet and hp at wheels peaked at 252. Allowing 15% drive train loss, comes out to 296 crank hp at 6800 rpm. Hp and torque curves are smooth and progressive. Air/Fuel ratio dropped down to 12.8 from 14.7 and remained straight line.
I have toyed around with differant settings but always end up back at the recommended setting. The system came with excellant instructions and tech help is very good. I highly recommend the Split Second.

Jim
'88 M6
Dinan Sprocket/Chip
Fahey track pipe




Follow Ups:


[ Follow Ups ] [ M5 (E28) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.