The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
piece of cake. just 2 small screws... (archive)
[ Follow Ups ] [ M5 (E28) Message Board ] [ Msg. Board FAQ ]
Posted by Bruce on July 03, 2002 at 03:16:57:

In Reply to: How Do You Install the Front Seat M-Emblem? posted by Lamar on July 03, 2002 at 03:01:18:

Remove the back panel of the seat back by removing the 2 small philips screws at the bottom. There are some seat positions that make this easier, but a short handle screw driver is the easist way. The panel just pulls straight down afterwards.

THen it is obvious, the "nails" are pushed through the seat and bent over.
I had the same thing happen, ( the new ones are dirt cheap - imagine my surprise ) I used the old one as a gauge on how tight to make it before bending the nails over. I think I went a bit looser to keep the plastic from bending as much.



My front passenger's side M-emblem broke in two, so I pulled it out and superglued it back together. However, the way those mounting nails are arranged on the emblem, I can't figure out how to get the emblem back into the seat. Is there some trick to it?




Follow Ups:


[ Follow Ups ] [ M5 (E28) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2008 Jump Internet Inc. All rights reserved.