The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: Problem with fresh air blower (archive)
[ Follow Ups ] [ 3-series (E30) Message Board ] [ Msg. Board FAQ ]
Posted by Chuck W on November 13, 2000 at 23:05:08:

In Reply to: Re: Problem with fresh air blower posted by Houston on November 12, 2000 at 20:33:40:

Resistor 3 is .35 ohms, Resistor 2 is .9 ohms and Resistor 1 is 1.6 ohm according to Bentley. Those are pretty low readings and I would guess hard to measure. Point is they should measure almost zero.


The resistors on mounted on a small plate located under the blower motor. The plate is "plugged in" in the back. Pull upward firmly, with a little wiggle side-to-side and it should come out.

If you have a multi-meter, you can probably check the resistors. I can't remember if the manual lists the different resistances or not.

Houston
86 325




Follow Ups:


[ Follow Ups ] [ 3-series (E30) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.