|
Total Power: 425 watts
Other Details: RMS continuous power bridged into a 4ohm load from 20 to 20,00 Hz, with less than .1% Total Harmonic Distortion @ 14.VDC
Signal to Noise Ratio: Greater than 98 db
Bandwidth: 20-50,000 Hz
Damping Factor @ 4ohm: 100 to 1
Slew Rate: 15.5 volts/usec
Crossover: Switchable high or low pass 12 dB/octave,continuously variable from 30 to 300hz
Input Independence: 20k ohms
Input Sensitivity: Variable from 200mV to 2 volt
Output Independence: 2 to 8 ohms, stereo/ 4 to 8 ohms, bridged
Supply Voltage: 10 to 15 VDC
Fusing and Power Cable Requirements (AWG): 50 A (2 x 25)
More Details:
High-Efficiency MOSFET switching power supply
High Current Complimentary Darlington Outputs
Short circuit, clipping, and thermal protection with LED inidicators
Stereo, bridged, or simultaneous stero and mono operation
Stable into 2ohm loads at input voltages as low as 10VDC
Flexible on-board active crossover with fully variable low or high pass output
Full range RC output for advanced multi-amp installations
Switchable Band Pass function enhances suberwoofer performance
Variable input sensitivity optimizes match with different signal sources
Gold Platted wire terminals and RCA connectors ensure maxium signal transfer
Rugged one-piece extruded heat sink with lower profile for ease of installation
Looks brand new, not damaged at all.
$200.00 buyer pays shipping.
Michael Abrahams
bavarian3@microd.com
© 1997 -
2008
Jump Internet Inc. All rights reserved.
