|
In Reply to: Instrument cluster / electronics gremlins? posted by Matt Dolan on May 20, 2001 at 22:46:45:
Perhaps pull you instr. console. Check that the electrical connectors to rear of console are properly connected/seated. The remove the connector plugs and check for any corrosion on connector pins. If ok. then disassemble cluster (to get inside to gauges) and check main printed circuit board that gauges are mounted on; there may be corrosion or poor connections (from gauges to PCB). But sounds like perhaps just connector problem going to entire console; as you said all gauges (except fuel??) stop operating. Pulling console is not difficult.
Not sure what is problem w/fan switch; again, perhaps bad connector.
Hope this helps / good luck / Bill