The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Spring sagging and other like questions... (archive)

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Posted by KevinS on July 13, 2000 at 18:50:56:

I just put in aluminum control arms, front upper bearings, offset bushings, rear upper busing (Cabrio), a set of Bilstein Sports, and H&R Race springs.

The springs did not seem to lower the car as much as advertised (1.6F 1.5R) and I was wondering how long it takes for them to sag and settle into place? The car seems noticably lower, but not as drastically as I was lead to beleive (internet hearsay).

The set up is also pretty nice to drive on so far. It doesn't seem any harsher than setups I've driven with regular H&R sport springs (non-M3 cars).

BTW, this was all install last night after work.

Anyone have any expectancy or other ideas about the set up? The back is nice but the front doesn't seem that low. Were there components that are stock but should have been left out during the install (front rubber pads on the spring perches etc.)?



Follow Ups:

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk. Logo © 1997 - 2016 Jump Internet Inc. All rights reserved.