The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: part numbers and installation? (archive)

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Posted by Jon Porath on August 01, 2000 at 16:46:58:

In Reply to: part numbers and installation? posted by Doug on August 01, 2000 at 09:39:12:

The parts and prices are at the link below. The prices are well out of the realm of normal ///M car prices so be prepared otherwise you might have heart failure when you see them.

The procedure is not difficult, but it's not exactly a walk in the park either. Bentley's and Koala Motorsports CD are good things to have to help you. I'll outline what I did.

Remove shift knob.
Remove shift boot.
Drop the exhaust.
Drop the driveshaft.
Drop the heat shield.
Remove the clips holding the shift lever to the shift linkage. Pull the lever from the linkage.
Remove the rear shift carrier mount.
Remove the two front carrier bolts.
Expand the ring around the knuckle.
Pull the pin holding the knuckle on.
Remove the knuckle. Clean out the sludge. Put new bushing in.
Assembly is the reverse of removal.

Piece of cake! Actually, it took me about 2 1/2 hours to do it but I could probably do it in an hour or so now. One thing to remember is that the to exhaust bolt goes into a nut welded to the flange. Remove it from the rear using a 2 foot long extension.

Also, since you have to drop the guibo, inspect it for cracks and have a new one ready in case you want to replace it.

Good luck


Follow Ups:

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk. Logo © 1997 - 2016 Jump Internet Inc. All rights reserved.