The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
I replaced the alternator with a different model (archive)

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Posted by JohnA on September 15, 2000 at 13:50:59:

In Reply to: Alternator mount wear/failure posted by JamesM on September 15, 2000 at 06:55:56:


I was going to do a quick alternator bushing replacement last night. I should have expected the worst before I started...

I noticed the belts would squeak above 4000rpm. So I checked the alternator, and it seemed a little crooked. Bushings. Common problem with the OEM rubber units. So I bought some circlip pliers, got new urethane bushings, and set off to do it last night. Got the alternator off. Noticed that the pivot bolt was WORN down into an odd shape, and it was about 1/2 its original diameter. It didn't break! Examined the alternator, and noticed that the steel sleeve inside the rubber was partially hogged out. Sh*t. Took off the bracket from the engine, and found the front hole looked like it was double wide, the rear hole was "L" shaped. Went to the Sears Hardware store, got a couple new bolts, 7mm and 8mm washers, and an Oxy-MAPP brazing kit. I brazed two 7mm washers onto each bracket flange. That took about 30 minutes. Since they were a 7mm hole for 8mm bolts, I used a 5/16 drill bit to ream them out. The 8mm bolt shaft fit perfectly. Bolted everything back up, cleaned up, and took it for a spin. No more belt squeak, and I'm not worried that my belt will get shredded while on the beltway or stuck in traffic. Yes, I'm ordering NEW parts from the dealer to fix it.

This happened to my friend at Roebling. His bolt actually broke. Twice in the same weekend. This has also happened to others, I'm assuming. Has anyone done anything to make the factory mounts better so this bolt breaking/hole reaming doesn't happen anymore? I was thinking you could drill the flange holes and sleeve out to fit an M10 bolt (17mm head). This may be a little complicated, but I'd imagine that it would probably be worth it.

James M
88 M3 Henna


When my alternator was due for replacement I found a Bosch alternator with same amp (90?)as original but without the bushings. It bolted on perfectly. I think it originally fits 318i engines. I'm a bit worried but I haven't experienced anything bad yet its been almost a year.


Follow Ups:



[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2016 Jump Internet Inc. All rights reserved.