In Reply to: Aux fan & back up lights help! posted by Chip on September 16, 2000 at 14:20:26:
1. No back-up lights. Fuse and bulbs are good; So i suspected the switch is bad.
Re: switch - Once the car is on jackstands, you can access the switch on the drivers side of the transmission. I did not need to remove/disconnect the slave cyl. I used a 19 mm deep socket (12 point probably better, but 6 point works) with a 3/8" flex handle to break it loose. You can spin it off and spin the new one on, then retighten with the same tool. Getting the wires off/on was a bit tricky, but not impossible. One caution-my switch bench-tested fine but didn't work on the car. Good luck!
2. aux fan does'nt work. Cause the two black wires on the tem sensor broke off; but the green one.
Any helps or tips on fixing these two broblems would be appreciated.