The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Alignment Specs (archive)

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Posted by Paul on December 20, 2000 at 20:21:37:

Thought this is the best place to get an answer. I've swapped factory M3 front & rear springs, M3 rear sway bar, iC front sway bar, new BOGE Turbo gas shocks onto my 90 325i 4dr. I didn't use the front M3 offset bushings. I know the alignment will be off but would it be better to try and make the alignment work using M3 specs or 90 325i? I realize that neither will be exact and that the camber won't be fully correct without camber plates but really only concerned with toe in/out for this street car at this point. I can probably slot the bolt holes in top of the strut towers if camber not off too far. Any suggestions appreciated.


Follow Ups:



[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.