In Reply to: Re: Eric88M3, ??'s about motor mount install posted by Eric on March 12, 2001 at 00:15:26:
Tell us more about you motor mount install. did you have to disconect any wiring, fan blade, water hoses, tranny mounts, etc... i read that you just unbolt the mount, jack up the engine an inch or two and slide them out. This seems too easy, is this what you did?
Thanks for the info,
I didn't disconnect anything, just jacked the car up, supported the engine, and swaped them out. I didn't really worry about the fan, mainly because it's pretty beat up as it is (missing two blades) but one time i did notice that the fan was pressed up against the shroud, so be careful of that.
this is what I did on the passenger side
unbolt the bottom of the motor mount
unbolt the 4 bolts that connect the engine mount connecter to the block ( you will understand when looking at it) I went this wroute becuase I felt that it would be easier from working uner the car to unbolt the whole engine mount assembly from the block that trying to get the top engine mount bolt from under the car.
on the driverside, I just unbolted the bottom from below the car, and the top from above the car. it is much easier to get to the top part of the mount if you remove the carbon canister. just unscrew the clamp, and push it twards the firewall/engine. get a big extension, one that alows you to turn the wrench above the air plenum, then just have at it. putting the carbon canister back in was a bit of a trick, you have to loosen the clamp up all the way, and wiggle the thing in.
when I re-installed the both mounts, on the under side, I got 5cm washers and placed them between the sub-frame, and the bolt. this spreads the load of the engine out, which should allow less chance of the sub-frame from cracking.
If i missed anything or described anything wrong let me know.
Did you get a chance to replace your tranny
mount? I would like to know the steps you
have taken to install it. did you use stock transmision mount? or you use the E-24 tranny mount I have order the stock motor mount and its on it's way I figure I do both at the same time while I'm at it. thanks in advance for any advice.