The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: yes eom (archive)
[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Posted by andyman on April 08, 2001 at 07:31:27:

In Reply to: yes eom posted by Eric on April 07, 2001 at 20:57:21:

why'd you replace the slave cylinder? because it was hard to shift? did that on my e28 and it turns out that my slave cylinder was fine and it's my throwout bearing which has died. Slave cylinder is always a good start though since you don't have to drop the tranny to replace it.

I just replaced the clutch slave cylinder, and the car still wont go into gear when the engine is running. It is more difficult to put the car in gear when the car is off than it was 2 weeks ago. Any suggestions
thanks
Eric
88M3

Eric,
Did you bleed it after you replace it?
RogerJ




Follow Ups:


[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.