In Reply to: Re: Half shaft and CV joint replacements?? posted by Angus on May 19, 2001 at 13:33:05:
Anybody change the Half shaft, CV joints and rear wheel bearing recently??
Just wondering if there are any pitfalls or things to watch out for or tips.
c/v joints are fairly easy the wheel bearing you will need a special tool to press hub out and then bearing in and out of spindle, a pricey tool! and of course not the same tool as the one needed to do the front wheel brgs, Argh so much for engineering simplicity
Going to buy the ST tool from Skyway.
Can you offer any practical advise or tips??