i think the diagram is a bit mixed around (archive)

Thanks Mark, and those potential helpers!
Why you ask am I doing this? So I can get off these BMW message boards, I need a break.
Hear is my shitty diagram!
I want to install my:
Kenwood head unit using the RCA's....
Into my Alpine 11 band Eq........
Into my Rockford Fosgate 600w 5 channel amp.
And out through new speaker wires from the Amp to the speakers!
Is this dumb, and am I asking for to much trouble? Do I need line-out filters? Since the New head unit has 2 sets of RCA plugs, am I screwed since the EQ only has 2 RCA inputs? Would my handy "Y" connectors help, and will I still have balance & fade? In the colorful wire area, I'll be skipping the speaker wires, would I be skipping anything else?
OOOOOOOOOR!
Should I try and work with what I got? Then why have an amp or an EQ? Isn't wiring the speakers from the amp, from where you get the gusto and the clearer sound? The Amp has built in Crossovers, does that help?
Thanks for reading!
Theeeeeee End?

I think that you should have a front left and right as well as a rear left and right. no? since the EQ only has one imput, unfortunately you cannot do fade front to rear, but since I"m asuming that your alpine EQ has front and rear Pre outs also, you can send a signal to all 4 interior speakers and your sub through the amp. your y adaptors won't do a think, don't use them
hope this helps
Eri
88M3
92 525iT

Follow Ups:

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Questions, comments, or problems, please visit the Roadfly help desk.