The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Or... (archive)

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Posted by Jon on September 07, 2001 at 14:21:57:

In Reply to: bushing installation could cause squeal..Example posted by Doug on September 07, 2001 at 13:43:05:

You can hammer them in. Just make sure you are supporting right under the bushing, not on the pulley, connections, etc. Also, why use soap? It's not like you need them to stick in there after the soap dries. Just use grease. It'll make them easier to change next time too.

-Jon


For instance, I installed those red urethane bushings several months ago and I have to admit I wasn't as gentle as I should have been with it. I soaped them down and tapped them into place with a hammer. While working on the bench in my garage I rested the alternator on it's external blades by accident while I hammered the back ones in. I guess the blades were tweeked just enough to cause imperfection of the internal berrings. Now I have a slight squeak but not from any of the belts. It's the only thing I can attribute it to since there was no squeak before the bushings were installed and isn't really audible most of the time. Leason to be learned here, "Have those installed by a shop with a good press". Oh and use the white Bosche bushings too.





Follow Ups:



[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.