The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
if the sensors don't do it then...... (archive)
[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Posted by GilesL on January 07, 2002 at 05:47:57:

In Reply to: Break Lining light goes on & off posted by M3andM3 on January 05, 2002 at 21:30:25:

You should re-flow the solder on all joints on the main board in the cluster....Whilst you are there you may as well do the Ni-Cads on the SI board.... The solder on my board was so bad that the components wobbled!!!! It fixed my flashing brake lining light.



The break pads are good and the the break lining light
goes on and off by itself. The breaks work fine. Someone
told me that the 'motherboard' should be fixed/replaced to
cure this problem. Where is the motherboard located?
Would it possible that the SI board battery is no longer
working correctly?
Please share your experience on this matter.
TIA
M3andM3




Follow Ups:


[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2008 Jump Internet Inc. All rights reserved.