The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: Rev limit with Schrick cams (archive)

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Posted by Roops on January 23, 2002 at 06:55:51:

In Reply to: Rev limit with Schrick cams posted by Adrian P on January 23, 2002 at 06:02:30:

I have just had my car "Schrick'd". The standard rev limit causes the power to drop off when the rev. limit is hit. Therefore when the car goes in for re-mapping tomorrow, the limit will be raised to take advantage of the cams. Give Nigel at Bexley Motor Works a call, on 0208 304 9797. He has done this a load of times and will be able to give you a definitive answer. I know he is running Schrick's & standard springs and revs his car well past the standard limit with no problems.

Roops

I have Schrick cams 284 inlet and 276 exhaust. Schrick tell me that they are safe to the standard red line but have not explored past that with stock valve springs. I am tentatively revving it to 7,400 rpm but it would happily pull to nearer 7,750 if it was safe. has anyone got any experience of running these cams with standard springs and explored the rev limit (they are 284 degrees vs 264 standard on the inlet 11.5mm of lift vs 10.7mm lift standard, 276 degrees exhaust vs248 standard and 11.4mm lift vs 10.2mm I think) From these figs it is possible that the extra lift is not gained by additional valve acceleration since the duration has been increased. Obviously without a very thorough mathematical analysis of the cam acceleration and 'jerk' it is impossible to take an educated view hence the need for trila and error (I would just rather the error wasn't mine !)

Tks
Adrian





Follow Ups:



[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.