The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
The clutch is bolted to the flywheel... (archive)

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Posted by michael on February 22, 2002 at 08:53:24:

In Reply to: Trans removal question?? posted by comment adam on February 22, 2002 at 01:19:46:

and will not be an issue. The 4th bolt that hold the tranny, the upper driver's side to the bell housing is a bi#ch to get to with out a special BMW werench. Consider the benifits of pulling the bellhousing...
You can replace the rear seal.
You can replace the throw out bearing.
You can replace the pilot bearing.

All these parts are inexpensive and will fail over time. It is a 4 hour job to R & R the tranny, seems foolish to not replace the things that you know will need to be done later.


Follow Ups:



[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.