The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: intake gasket questions (archive)

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Posted by JPL on February 25, 2002 at 10:02:34:

In Reply to: intake gasket questions posted by Gerald Williams on February 24, 2002 at 22:17:23:

You might consider getting the Korman Heavy Duty Accumulator Support too. Costs around $15. Check the two smaller 90 degree manifold fittings to see if they are loose. If so use Locktite sleeve retainer on them. Also check the large one on the accumulator itself. The fix for this one is to drill tap the accumulator and put in a small set screw. If this pops off at WOT - very lean, very bad.

JPL
90 m3
black and tan


hey guys,
i am replacing my intake manifold gaskets in my car, I was wondering if their is any kind of special boding or lub that is required when putting them in. Thanks,
Gerald Williams
1990 M3




Follow Ups:



[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.