Re: intake gasket questions (archive)

if you are using the M5 paper gasket,i would just coat the paper gasket with a light coat of motor oil. do the same thing between the intake gasket side and the paper. you might also check
the air intake plenum bracket where it is attach to the engine they are prone to cracking due to
the high frequency vivebration of the engine.
RogerJ.

You might consider getting the Korman Heavy Duty Accumulator Support too. Costs around $15. Check the two smaller 90 degree manifold fittings to see if they are loose. If so use Locktite sleeve retainer on them. Also check the large one on the accumulator itself. The fix for this one is to drill tap the accumulator and put in a small set screw. If this pops off at WOT - very lean, very bad.
JPL
90 m3
black and tan

hey guys,
i am replacing my intake manifold gaskets in my car, I was wondering if their is any kind of special boding or lub that is required when putting them in. Thanks,
Gerald Williams
1990 M3

Follow Ups:

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Questions, comments, or problems, please visit the Roadfly help desk.