The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Easy.... (archive)

[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]

Posted by [email protected] on May 28, 2002 at 16:35:30:

In Reply to: yeah, like that - any info on it?? posted by Doug on May 28, 2002 at 15:13:52:

1. Used film cannister
2. Momentary pushbutton switch
3. Lamp wire
4. Banana plugs/wire end connectors
5. Soldering tool and solder

Get #1 from home or a camera shop, #'s 2-6 from Radio shack. Just cut a hole in the cap of the cannister and screw in the switch, then solder the lamp wire to the switch, drill a hole in the bottom of the cannister, and run the wire through the hole. Attach the plug ends and you are done. If you want to be thorough about it, glue the cap shut.

One thing you should not do is put any kind of resistor in line, as the amount of current needed to go through the wire is pretty hefty (NOT like when doing a service light reset). As such, make sure you jump the right pins when you use the tool.

I use mine all the time for adjusting valves, testing compression, etc.

Good luck!
Matt






Follow Ups:



[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.