The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Referring To The 76mm Round Tips (n/t) (archive)
[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Posted by D///M3 on July 08, 2002 at 22:51:16:

In Reply to: installed the DTM type, no problem, it was a posted by Jose Perez on July 08, 2002 at 22:49:18:


bolt on removal of the BORLA, and fix the the DTM without any problem (10 minutes installation).
The pipe fits the shape of the rear balance, under the bumper, like a custom made one. The sound is really nice.

I installed my straight pipe center section (non-Euro resonator) & dual 76mm Round Tip exhaust. The fit is for CRAP. I had to remove the factory "welded" bolt on the top of the exhaust because it rested against my bumper cover (l/s of it). I then had to MacGyver a 1 inch spacer with a longer bolt/nut to bring the exhaust over to the right side so the tips would be centered in the bumper. Now, everything is centered, but the lower section of the exhaust sits tilted to the right. Just beautiful- Arrgh.

I know I'll have to completely remove the entire exhaust AGAIN & dick around with it so it's perfect. But, my question is-

Where do your exhaust tips come out? Mine are completely even with the edge of the bumper cover. Should they not come out more?

On a decent note- the exhaust sounds nice, not too bad for no cats. It does have a nice tone to it, especially on I-95 doing 45mph in the left lane-)

Thanks-
D///M3
'88 E30 ///M3
'85 E30 325e
Ft. Lauderdale





Follow Ups:


[ Follow Ups ] [ E30 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.