The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Thank you (archive)
[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Posted by Jerry on November 26, 2000 at 22:26:17:

In Reply to: Re: Low beams and front bumper removal help, pleas posted by eric on November 26, 2000 at 17:09:15:

I did the second option (had to use some penetrating oil for screws), it worked fine, now is the time to pass TI.

Thank you very much for your help!!!
Jerry

If you are replacing the entire assembly, there are 3 Phillips-headed screws to remove from the FRONT of the cluster (above each reflector, and at the lower, inside corner). There are also 3 screws to remove from INSIDE the engine compartment, all at the outside edge of the assembly. The topmost one is slightly outboard and down from the white headlight adjuster screw, I could only find it by feel, but it is there! Be careful not to lose these screws when taking 'em out.

Hope this helps!

eric
'88 735i 5sp




Follow Ups:


[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.