The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Thanks!!! (archive)
[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Posted by Jim Fredrickson on March 18, 2001 at 22:11:47:

In Reply to: Re: Transmission/Bell houseing bolt torque rateing posted by Wayne McKay on March 18, 2001 at 18:04:01:

Thanks again!!!



Here is all of the tightening torques copied from Bentley for your transmission (assuming 4HP22EH automatic not manual):
- ATF cooler line coupling nuts...21 Nm (15 ft-lb)
- ATF cooler line hollow bolt M14/M16...38 Nm (28 ft-lb)
- ATF filler tube to ATF sump...98 Nm (72 ft-lb)
- ATF sump drain plug (M10)...16 Nm (12 ft-lb)
- Driveplate to crankshaft...105 Nm (77 ft-lb)
- Rear transmission support to body...24 Nm (18 ft-lb)
- Torque convertor to drive plate (M8)...26 Nm (19 ft-lb)
- Torque convertor to drive plate (M10)...49 Nm (36 ft-lb)
- Transmission reinforcement plate...24 Nm (18 ft-lb)
- Transmission to engine (M8 Torx-head)...21 Nm (15 ft-lb)
- Transmission to engine (M10 Torx-head)...42 Nm (31 ft-lb)
- Transmission to engine (M12 Torx-head)...63 Nm (46 ft-lb)

Hope this helps,
'88 750iL


Does anybody have the torque rateings for a bell housing on the transmission of a 1988 735i. Thanks in advance!!!

-Jim





Follow Ups:


[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.