The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: Rear Seat Removal iL models (archive)
[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Posted by Doug Meinen on June 11, 2001 at 15:35:23:

In Reply to: Battery posted by Bryan Garner on June 10, 2001 at 22:06:43:


Bryan

I though you have a Bentley Manual?

But any way.

On page 520-8 of the Bentley Manual states Rear Seat Cushion Removing and installing (Power Seats)

Pull front of cushion up and out of clip

Remove seat control knobs and remove trim screws behind them.

Pull up seat belt lock trim and remove from seat belt lock. "need to see picture"

On Rear door edge trim retaining clip "need to see picture"

Pull off door seal at bottom rear corner of door. Tilt door edge trim outward and remove.

Unbolt rear seat belt lock mounting bolt and disconnect wiring harness connector "need to see picture"

Lift front of sear cushion, sliding seat tracks off body anchors and unhooking locating rods from backrest.

Detach electrical harness connector and lift cushion out of car.

Installation is reverse of removal.

Hope this helps
Doug
'88 735i



Follow Ups:


[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.