The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: M60 Problem with power (archive)
[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Posted by David Morton on July 29, 2001 at 13:13:03:

In Reply to: M60 Problem with power posted by Ilya on July 29, 2001 at 12:17:55:


If i take accelerator fully down (drive is very fast) the power will be is very low.
After reseting computer (take off the battery) and start ingine - power is OK.

I think - is oxigen sensor. May be not.

Please help.

Thank.

The Bentley Bible Recommends the following:

CO Content too low/Check air flowor mass air flow sensor.

input signalsto ECM missing, ECM in limp home mode/Test DME ECM connector .

ECM Faulty/ Test DME ECM Inputs, If all OK replace ECM.

Fuel pump delivery too low/Test Fuel Pump.

Fuel Pressure too low/ Check pressures.

A Hypothetical suggestion.... It could also be the throttle mechanism, (Someone butt in here!)
If I'm right the later model E32 had a "Throttle Potentiometer" That is your accelerator is electronically controlled, this could be faulty.

Try These.
Good Luck

Dave M


Follow Ups:


[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.