The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Here's what i did, not original standoffs though.. (archive)

[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]

Posted by Rainman on August 10, 2001 at 12:08:39:

In Reply to: Re: Thanks...about to do the same posted by JarJar Binks on August 10, 2001 at 11:09:41:

If using the existing standoffs, I offer this caution (forgive me if this is obvious to any readers already).

When drilling a couple of holes to hold the sink against the MOSFETs mounted on the old stand-offs, make sure they are positioned through the wide traces on the PCB that the existing standoffs are attached to. In electronic terms, the bolts will be in parallel with the standoffs.


Follow Ups:

[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk. Logo © 1997 - 2018 Jump Internet Inc. All rights reserved.