The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: 740I CYLINDER HEAD TORQUE (archive)
[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Posted by Larry on October 07, 2001 at 17:23:11:

In Reply to: 740I CYLINDER HEAD TORQUE posted by Rob on October 07, 2001 at 16:15:59:

A protractor or special tool bmw number 11 2 110 is needed to torque the head bolts on the M60.

stage 1 = finger tight
stage 2 = 30 Nm(22 ft-lb)
stage 3 = +80 degrees
stage 4 = +80 degrees

sequence is as follows
7 5 1 3 9

10 4 2 6 8

If they machined the heads they should have used a special head gasket that is .03 mm thicker. hope this helps

Larry
1994 740il

What is the proper torque and sequence for m60 cylinder head bolts. Short block replaced by BMW within the last 5k miles. There is a minor amount of oil around bolts. Should dealer have brough car back in to retorque? If so, when? Some of the bolts appear to be a little loose.




Follow Ups:


[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.